World · North America · 37 mins ago
FAA ground stop followed router disruption during maintenance
The FAA grounded all departing flights across the United States on Friday after a communications disruption spread through its air traffic network.
The problem began during routine work by contractor L3Harris to replace old copper lines with fiber at a site in El Dorado, Arkansas.
A newly installed router sent data at a high rate, affecting communications at 17 of 22 centers that guide high-altitude flights.
The nationwide stop lasted more than four hours, and airlines canceled thousands of flights as they moved crews and aircraft back into place.
Investigators have not determined whether a setup mistake or faulty equipment caused the failure.
The disruption has raised concerns about an aging system and a modernization program that auditors say lacks a master schedule.
The FAA disabled similar routers and is reviewing maintenance plans, while officials say the cause remains under investigation.
A maintenance-related communications failure led the Federal Aviation Administration to stop all US departures for more than four hours on Friday.
The disruption followed work by FAA contractor L3Harris to move telecommunications lines from copper to fiber at a remote site in Arkansas.
The FAA said two locations were sending data to its network at a high rate, and it disabled them to stabilize the system.
Officials have not established whether the cause was contractor error or faulty equipment, and the FAA said there was no evidence of malicious activity or artificial intelligence involvement.
Airlines canceled thousands of flights as they repositioned crews and aircraft, while officials said aging infrastructure needs modernization.
- Who
- The Federal Aviation Administration ordered the ground stop; L3Harris was doing maintenance for the agency.
- What
- A nationwide flight ground stop followed a communications failure during maintenance. The stop lasted more than four hours.
- When
- Friday afternoon; the sources give dates of November 13 and November 16, 2026.
- Where
- Across the United States, after work at an FAA radio site in El Dorado, Arkansas.
- Why
- A router overloaded communications during work switching lines from copper to fiber. Officials have not determined whether contractor error or faulty equipment caused the failure.
This story does not have two clearly opposing sides.
L3Harris was upgrading telecommunications lines at a remote FAA site in El Dorado, Arkansas.
The FAA held all departures nationwide while about 3,500 planes were in the air.
The nationwide ground stop ended after more than four hours.
The FAA disabled approximately 60 similar routers as a precaution and said the network had been stabilized.
Airlines had canceled more than 5,000 flights, with about 1,500 more canceled on Sunday, according to Fast Company.
- Ground-stop start
- Friday at 3:36 p.m. Eastern
- Ground-stop end
- Friday at 8:15 p.m.
- Maintenance contractor
- L3Harris Technologies
- Maintenance site
- El Dorado, Arkansas
- Affected en route centers
- 17 of 22
- Router precaution
- Approximately 60 similar routers disabled
6 sources
"Tiger team" formed to head off another nationwide ground stop
The FAA’s ground stop has a simple culprit. Its causes may not
With the busiest travel season ahead, how likely is it that another FAA ground stop happens?
L3Harris Finds Itself Back in the Spotlight After ATC Meltdown
Nationwide flight ground stop caused by routine maintenance error
Aviones en tierra, caída de Microsoft y caos de la IA, ¿puede romperse todo?: "Las guerras ya no se hacen con bombas"
What people are saying
We haven’t determined what the fault was.
We’re making the transition not because we want to spend money. We’re making the transition because it’s safer and it’s more resilient.
Based on what we know and have been told by others, our equipment was working as configured.
We did not.